Parts & Equipment Wish List
Needed to restore submarine
revised 10/28/09 If you can donate any of the needed parts or equipment, please email the Museum Curator at
This e-mail address is being protected from spambots. You need JavaScript enabled to view it
USS BOWFIN "MOST WANTED" PARTS/EQUIPMENT WISH LIST
- Small clocks
- Light bulb sockets
- 50 cal. Machine guns and mounts
- Washing machine, 20" x 20" open-end with wringer, American Laundry Machine Co.
- 40 mm complete gun M1 and mounting (Navy type)
- Compass, armored vehicle, magnetic, Mk 1 Mod 1, Stock No. G6605-494-0805 (TWO)
- Barometer, Aneroid Dupblx scale 4 ¾" case, Stock No. G6685-290-4043 (FOUR)
- Diving alarm contact maker, Type MVII, Stock No. G6605-494-0805
- ME #1 fuel pump and ME #2 fuel pump
PRIMARY PARTS & EQUIPMENT WISH LIST
- 2 Depth Gauges, salt water, 16" dial 15’-166’ range, Stock No. P45-6-35-900
- 2 Depth Gauges, salt water, 8 1/2" dial 0’-600’ range, Stock No. P45-6-35-100
- 1 Depth Gauge, salt water, 8 1/2" dial 26’-176’ range, Stock No. P45-6-35-510
- 2 Compartment Pressure Gauge, 6" dial, Stock No. P45-6-27-100
- 3 Inclinometer, tube type (Trim Angle Indicator), MK-4 Mod. 0, Stock No. G6605-276-9249 1 TBT for bridge (complete assembly)
- 2 Diving Alarm Klaxon, Type MVII, Stock No. A-17-C-33966
- 2 Diving Alarm Contact Maker, Type MVII, Stock No. G6605-494-0805
- 2 Propellers
- Clocks* (Small)
- Battle Lanterns*
- 4 50 Cal. Machine Gun*
- 1 40 MM (Complete assembly)*
* QUANTITY DESIRED IS AS MANY AVAILABLE UNITS AS POSSIBLE
SECONDARY PARTS & EQUIPMENT WISH LIST
Forward Escape Trunk
- Compartment Pressure Gauge
- Depth Gauge
- Lever Handle for drain valve
Forward Torpedo Room
- I.D. Plates for all torpedo tubes
- Torpedo Hold-down Straps (all)
- Dive Angle Indicator and Pointer
- Regulators for oxygen bottles
- Screw cap for Charging Unit
- OBA Canisters
- Two Battle Lanterns
- # 1 outboard torpedo head
- Two Lithium Hydroxide Canister
Forward Battery
- Folding Table in Chief’s stateroom
Conning Tower
- Bearing and Range Indicator (over DRT)
- Drafting Arm for DRT
- Knob for collision alarm contact maker
- Magnetic Compass
- Deep Depth Gauge
- Shallow Depth Gauge
- Inclinometer (Trim)
- Inclinometer List
Control Room
- Master Gyro Line Bearing Indicator
- Compartment Pressure Gauge
- Hydraulic Accumulator Indicator
- I-MC Volume Gauge, (3 each)
- Magnetic Compass
- Diving Alarm Knob
- Diving Alarm Plate
- 3 Lithium Hydroxide Canisters
- Compartment Pressure Gauge
After Battery Room
- Oxygen Regulator
- Pea Coat locker doors
Forward Engine Room
- Oxygen Regulator
- Controller for exhaust fan motor
- M.E. #1 Fuel Pump
- M.E. #2 Fuel Pump
- 1 Lithium Hydroxide Canister
- Air Reducer – under forward water tight door
After Engine Room
- 1 Battle Lantern
- Oxygen Regulator
- One Lithium Hydroxide Canister
Maneuvering Room
- Air Reducer (outboard of lathe)
- Oxygen Regulator
- 2 Lithium Hydroxide Canisters
After Torpedo Room
- Diving Indicator Pointer
- Stern Diving Gear Auxiliary Tilting Indicator
- 2 Oxygen Regulators
- 2 Battle Lanterns
Topside
- Air Whistle (horn) for superstructure
- 20mm Gun Magazine
- Machinegun, 50 Cal. (4 each)
- Machinegun Mount Adapter, MK-II
- 40 MM (Complete Assembly)
- Handle for trainer –5" gun
- P.P. Bridge Switch Box Aft TBT
General
- Lithium Hydroxide Canisters, 12-15 lb. (43 each), (square can type)
- 7 MC (2 each)
- Washing Machine 20" X 20" open-end, with Wringer American Laundry Machine Co.
- Compass, Armored Vehicle, Magnetic, MK-1, Mod. 1, Stock No. G6605-494-0805 (two)
- Bearing and Range Indicator, MK-4
- Gyro Compass Repeater, MK-III, Mod. 1 7.
- Barometer, Aneroid Dupblx Scale 4 3/4" case, Stock No. G6685-290-4043
- Lock Handle assembly for lockers (10 each)
- Clocks 24 hour (six 5 1/2", small clocks)
- Assorted knobs, gauges, fittings, etc.
- Floor Moldings & Corners
- "Rocks & Shoals" (Uniform Code of Military Justice) (UCMJ)
PARTS WISH LIST FOR GUN AUTOMATIC 40mm, M 1 and MOUNT, GUN 40mm, M 3 ( NAVY TYPE)
- 2 pieces - M 3 (Navy type front sight ring)
- 10 pieces - Charger clip RAPD 21457A
- 2 pieces - Shell case deflector
- 1 piece - Handle 41-H-1549-522
- 1 piece - Shell ejector 41-E-29-25
- 1 piece - Plug key wrench 41-W-1969
- 1 piece - Side cover key 41-K-82-900
- 1 piece - Gun barrel carrier 41-C-435
- 1 piece - Equilibrator spring compressor assembly 41-C-2555-270
- 1 piece - Gun barrel carrier 41-C430
- 1 piece - Automatic loader feed rod spring compressor 41-C-2555-75
- 1 piece - Equilibrator base cover
- 1 piece - Equilibrator spring rod
If you can donate any of the needed parts or equipment, please email the Museum Curator at
This e-mail address is being protected from spambots. You need JavaScript enabled to view it
return to top
|