PARTS & EQUIPMENT WISH LIST

Needed to restore submarine
Revised: Spring 2016

If you can donate any of the needed parts or equipment, please email the Museum Curator at curator@bowfin.org

USS BOWFIN "MOST WANTED" PARTS/EQUIPMENT WISH LIST
  • Small clocks
  • Light bulb sockets
  • 50 cal. Machine guns and mounts
  • Washing machine, 20" x 20" open-end with wringer, American Laundry Machine Co.
  • 40 mm complete gun M1 and mounting (Navy type)
  • Compass, armored vehicle, magnetic, Mk 1 Mod 1, Stock No. G6605-494-0805 (TWO)
  • Barometer, Aneroid Dupblx scale 4 ¾" case, Stock No. G6685-290-4043 (FOUR)
  • Diving alarm contact maker, Type MVII, Stock No. G6605-494-0805
  • ME #1 fuel pump and ME #2 fuel pump
PRIMARY PARTS & EQUIPMENT WISH LIST
  • 2 Depth Gauges, salt water, 16" dial 15’-166’ range, Stock No. P45-6-35-900
  • 2 Depth Gauges, salt water, 8 1/2" dial 0’-600’ range, Stock No. P45-6-35-100
  • 1 Depth Gauge, salt water, 8 1/2" dial 26’-176’ range, Stock No. P45-6-35-510
  • 2 Compartment Pressure Gauge, 6" dial, Stock No. P45-6-27-100
  • 3 Inclinometer, tube type (Trim Angle Indicator), MK-4 Mod. 0, Stock No. G6605-276-9249
  • 1 TBT for bridge (complete assembly)
  • 2 Diving Alarm Klaxon, Type MVII, Stock No. A-17-C-33966
  • 2 Diving Alarm Contact Maker, Type MVII, Stock No. G6605-494-0805
  • 2 Propellers
  • Clocks* (Small)
  • Battle Lanterns*
  • 4 50 Cal. Machine Gun*
  • 1 40 MM (Complete assembly)*

*QUANTITY DESIRED IS AS MANY AVAILABLE UNITS AS POSSIBLE

SECONDARY PARTS & EQUIPMENT WISH LIST
Forward Escape Trunk
  • Compartment Pressure Gauge
  • Depth Gauge
  • Lever Handle for drain valve
Forward Torpedo Room
  • I.D. Plates for all torpedo tubes
  • Torpedo Hold-down Straps (all)
  • Dive Angle Indicator and Pointer
  • Regulators for oxygen bottles
  • Screw cap for Charging Unit
  • OBA Canisters
  • Two Battle Lanterns
  • # 1 outboard torpedo head
  • Two Lithium Hydroxide Canister
Forward Battery
  • Folding Table in Chief’s stateroom
Conning Tower
  • Bearing and Range Indicator (over DRT)
  • Drafting Arm for DRT
  • Knob for collision alarm contact maker
  • Magnetic Compass
  • Deep Depth Gauge
  • Shallow Depth Gauge
  • Inclinometer (Trim)
  • Inclinometer List
Control Room
  • Master Gyro Line Bearing Indicator
  • Compartment Pressure Gauge
  • Hydraulic Accumulator Indicator
  • I-MC Volume Gauge, (3 each)
  • Magnetic Compass
  • Diving Alarm Knob
  • Diving Alarm Plate
  • 3 Lithium Hydroxide Canisters
  • Compartment Pressure Gauge
After Battery Room
  • Oxygen Regulator
  • Pea Coat locker doors
Forward Engine Room
  • Oxygen Regulator
  • Controller for exhaust fan motor
  • M.E. #1 Fuel Pump
  • M.E. #2 Fuel Pump
  • 1 Lithium Hydroxide Canister
  • Air Reducer – under forward water tight door
After Engine Room
  • 1 Battle Lantern
  • Oxygen Regulator
  • One Lithium Hydroxide Canister
Maneuvering Room
  • Air Reducer (outboard of lathe)
  • Oxygen Regulator
  • 2 Lithium Hydroxide Canisters
After Torpedo Room
  • Diving Indicator Pointe
  • Stern Diving Gear Auxiliary Tilting Indicator
  • 2 Oxygen Regulators
  • 2 Battle Lanterns
Topside
  • Air Whistle (horn) for superstructure
  • 20mm Gun Magazine
  • Machinegun, 50 Cal. (4 each)
  • Machinegun Mount Adapter, MK-II
  • 40 MM (Complete Assembly)
  • Handle for trainer –5" gun
  • P.P. Bridge Switch Box Aft TBT
General
  • Lithium Hydroxide Canisters, 12-15 lb. (43 each), (square can type)
  • 7 MC (2 each) T1 (20 each) T2 (2 each) Transformer
  • Washing Machine 20" X 20" open-end, with Wringer American Laundry Machine Co.
  • Compass, Armored Vehicle, Magnetic, MK-1, Mod. 1, Stock No. G6605-494-0805 (two)
  • Bearing and Range Indicator, MK-4
  • Gyro Compass Repeater, MK-III, Mod. 1 7.
  • Barometer, Aneroid Dupblx Scale 4 3/4" case, Stock No. G6685-290-4043
  • Lock Handle assembly for lockers (10 each)
  • Clocks 24 hour (six 5 1/2", small clocks)
  • Assorted knobs, gauges, fittings, etc.
  • Floor Moldings & Corners
  • "Rocks & Shoals" (Uniform Code of Military Justice) (UCMJ)
  • 7 mc compartment selector switches (8 each)
  • Audio generator
  • AN/PSM-4 Multi-meter (2 each)
PARTS WISH LIST FOR GUN AUTOMATIC 40mm, M 1 and MOUNT, GUN 40mm, M 3 ( NAVY TYPE)
  • 2 pieces - M 3 (Navy type front sight ring)
  • 10 pieces - Charger clip RAPD 21457A
  • 2 pieces - Shell case deflector
  • 1 piece - Handle 41-H-1549-522
  • 1 piece - Shell ejector 41-E-29-25
  • 1 piece - Plug key wrench 41-W-1969
  • 1 piece - Side cover key 41-K-82-900
  • 1 piece - Gun barrel carrier 41-C-435
  • 1 piece - Equilibrator spring compressor assembly 41-C-2555-270
  • 1 piece - Gun barrel carrier 41-C430
  • 1 piece - Automatic loader feed rod spring compressor 41-C-2555-75
  • 1 piece - Equilibrator base cover
  • 1 piece - Equilibrator spring rod

If you can donate any of the needed parts or equipment, please email the Museum Curator at curator@bowfin.org